New - N Male Termination Load for Calibration -42dB to 1.2 GHz -36dB to 2.7GHz

Description

You are bidding on a new N male semi-precision load useful for terminations, as well as calibration of anritsu or other cable or antenna analyzers. The return loss is a very high performance 42 dB up to 1200MHz.  Between 1200MHz and 2700MHz the return loss is an acceptable 36dB.  Above 2700MHz the return loss is a useful 22dB, which will work well for network analyzer calibration.
Please refer to the performance curves.
Center Pin:  Brass with gold finish
Outer Parts:  Brass with nickel finish
Insulator:  Teflon
These loads do not pass the sorting to make precision or economy grade loads to 3GHz, but are perfectly adequate for lower frequency precision work to lower frequencies, or normal load applications to over 6GHz.
The load comes with a 5.5" (140mm) wire tether, that might be a good tie point for tower mounted equipment.  The length is measured from the center of the termination to the center of the lug fastening hole.  The hole will accept a #4 or M3 screw. The unit has an environmental gasket for semi permanent installation.
This is an excellent back-up load, especially for under 1200MHz, in case your OSL is damaged.