OBD-II Low Profile Right Angle Y Flat Ribbon Extension for Nexiq EESM607 ,72"

Description

Brand new highest quality Y splitter cable for OBD2 - the "Add-A-Port" cable.
Works with NEXIQ EESM607 to allow you to connect device and hide behind dash while leaving you diagnostics port open
Works with ALL 16 pin OBD-II devices and cables
This is THE BEST way to provide a second OBD2 port on ANY VEHICLE with OBD2...here's why;
One end has male/female feed thru connector - this plugs onto your existing OBD2 port and provides the same OBD2 in the same place as the factory with nearly transparent appearance! (see pictures in listing above of actual connection to OBD2 before and after)
Other end is a female OBD2 exact same as factory with a 180 CM/ 72" long ribbon cable
Both ends have the cable coming out at 90 degree so no bulky connectors to get in the way!
Takes your single OBD2 port and converts it to 2 OBD2 ports in seconds
All pins are wired so you can be assured you have any and all signals found on your factory OBD2 port!
Both ends are SAE J1962 Type A (standard connector for OBDII 12 volt vehicles)
Individually poly bagged and labeled!
Ships from the USA within 1 business of order!
Thanks for looking and I welcome any questions you may have!